TX, I think he got em from bat-inc. I helped him do the install and I asked him where he got them, but I can't seem to remember. But bat-inc sounds right. I think.
____________________ "Men and boys alike love burnouts because they involve machinery, loud noises, and destruction."
The ones that ford US has are the 03-04 model and are light as a feather. I have the US ones on my Z and the Bat inc ones on the Sony. I need some in a rush so I went to ford and got some with a discount and I think I spent 13-15 each on then and no shipping. I put the part number in the exterior mods in the sticky for part numbers.
to take yours off there are 2 flat spots on the rubber boot side. Just slide the rubber boot back(or rip it off) and put (i think) a 17mm open end on it and it should not spin. as for tightening do the same in reverse but the wrench may get stuck if you tighten to much, take it out and use the allen to finish it or find a skinny 17mm(or whatever size it is). This will save you a couple bucks due to shipping.
